 |
|---|
| 1. Remove exhaust valve control cables. |
| 2. Remove cable bracket from exhaust valve servo motor. |
| 3. Place warning light eliminator on to servo motor shaft. |
| 4. Eliminator bracket should have the "flat" side facing up. |
| 5. The center slot on the bottom of the bracket will fit on the servo motor shaft. |
| 6. Tighten down eliminator bracket using the factory nut. |
| 7. Turn the ignition on to test the servo. |
| 8. It should turn back and forth until the bracket touches the stops. |
| 9. The FI light will not stay constantly lit. |
| 10. You will still be able to tell if there are any problems with the fuel system. |